Traffic Load Spectra For Implementing And Using The Mechanistic Empirical Pavement Design Guide In Georgia PDF Download

The recently developed mechanistic-empirical pavement design guide (MEPDG) requires a multitude of traffic inputs to be defined for the design of pavement structures, including the initial two-way annual average daily truck traffic (AADTT), directional and lane distribution factors, vehicle class distribution, monthly adjustment factors, hourly truck distribution factors, traffic growth rate, axle load spectra by truck class (Class 4 to Class 13) and axle type (single, tandem, tridem, and quad), and number of axles per truck. Since it is not always practical to obtain site-specific traffic data, the MEPDG assimilates a hierarchal level concept that allows pavements to be designed using statewide averages and MEPDG default values without compromising the accuracy of the pavement design. In this study, a Visual Basic for Application (VBA) code was developed to analyze continuous traffic monitoring data and generate site-specific and statewide traffic inputs. The traffic monitoring data was collected by 143 permanent traffic monitoring sites (93 automated vehicle classifier (AVC) and 50 weigh-in-motion (WIM) sites) distributed throughout the State of Ohio from 2006 to 2011. The sensitivity of the MEPDG to the various traffic inputs was evaluated using two baseline pavement designs, one for a new flexible pavement and one for a new rigid pavement. Key performance parameters for the flexible pavement included longitudinal (top-down) fatigue cracking, alligator (bottom-up) fatigue cracking, transverse (low-temperature) cracking, rutting, and smoothness (expressed using IRI), while key performance parameters for the rigid pavement included transverse cracking (% slabs cracked), joint faulting, and smoothness. The sensitivity analysis results revealed that flexible pavements are moderately sensitive to AADTT, growth rate, vehicle class distribution, and axle load spectra; and not sensitive to hourly distribution factors, monthly adjustment factors, and number of axles per truck. Furthermore, it was found that rigid pavements are moderately sensitive to AADTT, growth rate, hourly distribution factors, vehicle class distribution, and axle load spectra; and not sensitive to monthly adjustment factors and number of axles per truck. Therefore, it is recommended to estimate the AADTT and the vehicle class distribution from site-specific short-term or continuous counts and obtain the truck growth rate from ODOT Modeling and Forecasting Section (Certified Traffic). As for the other traffic inputs, statewide averages can be used for the hourly distribution factors, axle load spectra, and number of axles per truck; and MEPDG defaults can be used for the monthly adjustment factors.