Vulnerability Of Reinforced Concrete Columns To External Blast Loading PDF Download

Previous events have demonstrated the vulnerability of reinforced concrete infrastructure to blast loading. In buildings, ground-story columns are key structural components, and their failure can lead to extensive damages which can cause progressive collapse. To prevent such disasters, the steel reinforcement in such columns must be properly detailed to ensure sufficient strength and ductility. The use of modern concrete materials such ultra-high performance concrete (UHPC) is one potential solution to improve the blast performance of columns. UHPC shows high compressive strength, high tensile resistance and superior toughness, properties which make it ideal for use in the blast-resistant design of columns. The combined use of UHPC and high-performance steels can potentially be used to further enhance the blast resistance of columns. This thesis presents an experimental and analytical study which investigated the use of high-performance materials to increase the blast capacity and ductility of reinforced concrete columns. As part of the experimental study, a total of seventeen columns were tested under simulated blast loading using the University of Ottawa Shock-Tube. Parameters investigated included the effect of concrete type (NSC and UHPC), steel reinforcement type (normal-strength, high-strength or highly ductile), longitudinal reinforcement ratio, seismic detailing and fiber properties. The test program included two control specimens built with normal-strength concrete, five specimens built with UHPC in combination with high-strength steel, and ten columns built with highly ductile stainless steel reinforcement. Each column was subjected to a series of increasing blast pressures until failure. The performance of the columns is investigated by comparing the displacements, impulse capacity and secondary fragmentation resistance of the columns. The results show that using high-performance steels increases the blast performance of UHPC columns. The use of sufficient amounts of high-strength steel in combination with UHPC led to important increases in column blast capacity. The use of ductile stainless steel reinforcement allowed for important enhancements in column ductility, with an ability to prevent rupture of tension steel reinforcement. The study also shows that increasing the longitudinal reinforcement ratio is an effective means of increasing the blast resistance of UHPC columns The thesis also presents an extensive analytical study which aimed at predicting the response of the test columns using dynamic inelastic, single-degree-of-freedom (SDOF) analysis. A sensitivity analysis was also performed to examine the effect of various modelling parameters on the analytical predictions. Overall, it was shown that SDOF analysis could be used to predict the blast response of UHPC columns with reasonable accuracy. To further corroborate the results from the experimental study, the thesis also presents an analytical parametric study examining the blast performance of larger-scale columns. The results further demonstrate the benefits of using UHPC and high-performance steel reinforcement in columns subjected to blast loading.